Cisco ONS 15310-CL Troubleshooting Manual page 295

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3097 The ring termination is in use.
EID-3098 No ring terminations selected.
EID-3099 Sorry, entered key does not match existing authentication key.
EID-3100 Error encountered during authentication.
EID-3101 DCC Metric is not in the range 1 - 65535.
EID-3102 Invalid DCC Metric
EID-3103 Invalid IP Address: {0}
EID-3104 Router priority is not in the range of 0 - 255
EID-3105 Invalid Router Priority
EID-3106 Hello Interval is not in the range of 1 - 65535
EID-3107 Invalid Hello Interval
EID-3109 Invalid Dead Interval value. Valid range is 1 - 2147483647
EID-3110 Dead Interval must be larger than Hello Interval
EID-3111 LAN transit delay is not in the range of 1 - 3600 seconds
EID-3112 Invalid Transmit Delay
EID-3113 Retransmit Interval is not in the range 1 - 3600 seconds
EID-3114 Invalid Retransit Interval
EID-3115 LAN Metric is not in the range 1 - 65535.
EID-3116 Invalid LAN Metric
EID-3117 If OSPF is active on LAN, no DCC Area Ids may be 0.0.0.0.
Please change all DCC Area Ids to non-0.0.0.0 values before
enabling OSPF on the LAN.
EID-3118 If OSPF is active on LAN, LAN Area ID may not be the same
as DCC Area Id.
EID-3119 Validation Error
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
The ring termination you are trying to
access is in use. Try after sometime.
Select one of the ring terminations.
Check the authentication key and reenter.
There was an error in authentication. Verify
that the key does not exceed the character
limit .
The DCC metric should be in the range of 1
to 65535.
There was an invalid DCC metric.
The IP address is invalid.
The router priority should be in the range of
0 to 255.
The router priority is invalid.
The hello interval should be in the range of
1 to 65535.
The hello interval is invalid.
The dead interval value must be between 1
and 2147483647.
Refer to the error message text.
The LAN transit delay should be in the
range of 1 to 3600 seconds.
The transmit delay is invalid.
The retransmit interval should be in the
range of 1 to 3600 seconds.
The retransmit interval is invalid.
The LAN metric should be in the range of 1
to 65535.
The LAN metric is invalid.
Refer to the error message text.
LAN must be part of a different OSPF area
other than the DCC network.
CTC was unable to validate the values
entered by the user. This error message is
common to several different provisioning
tabs within CTC (examples include the
SNMP provisioning tab, the General>
Network provisioning tab, the Security >
Configuration provisioning tab, etc.).
1-19