Cisco ONS 15310-CL Troubleshooting Manual page 291

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2328 Circuit reconfigure error.
{0}
EID-2329 {0} of {1} circuits could not be successfully created.
EID-2330 Circuit verification: selected {0} invalid!
{1}
EID-2331 Deleting {0} may be service affecting.
WID-2331 Deleting circuits may be service affecting. Really delete the {n}
selected circuits?
EID-2332 Hold-off timer validation error in row [0].
{1} hold-off timer for {2} must be between {3}-10,000 ms, in
steps of 100 ms.
EID-3001 An Ethernet RMON threshold with the same parameters
already exists. Please change one or more of the parameters and
try again.
EID-3002 Error retrieving defaults from the node: {0}
EID-3003 Cannot load file {0}.
EID-3004 Cannot load properties from the node
EID-3005 Cannot save NE Update values to file {0}
EID-3006 Cannot load NE Update properties from the node
EID-3007 Provisioning Error for {0}
EID-3008 Not a valid Card
EID-3009 No {0} selected
EID-3010 Unable to create bidirectional optical link
EID-3016 Invalid subnet address.
EID-3017 Subnet address already exists.
EID-3018 Standby TSC not ready.
EID-3019 Incomplete internal subnet address.
EID-3020 TSC One and TSC Two subnet addresses cannot be the same.
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
The attempt to reconfigure the specified
circuit has failed.
A few circuits could not be created.
The selected item, specified by {0}, is
invalid as per the details, specified in {1}.
Deleting the item can affect the service of
CTC.
Confirm whether you want to delete the
selected circuit. Deleting the circuit could
affect the service.
Refer to the error message text.
Change a few parameters in an Ethernet
remote monitoring (RMON) threshold and
try again.
There was an error while retrieving the
defaults from the specified node.
CTC cannot load the specified file.
Refer to the error message text.
CTC cannot save the network element (NE)
update values to the specified file.
Refer to the error message text.
There was a provisioning error for the
specified item.
You cannot perform DWDM automatic
node setup (ANS) from the Card view.
Please navigate to the Node view and try
again.
Select the specified item, for example,
VLAN, port, slot, etc.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The standby Timing and Shelf Control card
(TSC) not ready.
Enter the complete internal subnet address.
A node's internal subnet must be different
from one another as each TSC is on separate
ethernet buses, isolated by broadcast
domains.
1-15