Cisco ONS 15310-CL Troubleshooting Manual page 281

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2025 This feature cannot be used. Verify that each of the endpoints
of this circuit are running software that supports this feature.
EID-2026 Unable to apply {0} request. {1}
EID-2027 Error deleting circuit drop.
EID-2028 Error removing circuit node.
EID-2029 The requested operation is not supported.
EID-2030 Provisioning error.
EID-2031 Error adding node.
EID-2032 Unable to rename circuit. {0}
EID-2033 An error occurred during validation. {0}
EID-2034 Unable to add network circuits:
{0}
EID-2035 The source and destination nodes are not connected.
EID-2036 Cannot delete this {0}.
LAN Access has been disabled on this node and this {0} is
needed to access the node.
EID-2037 Application error. Cannot find attribute for {0}.
EID-2038 Invalid protection operation.
EID-2040 Please select a node first.
EID-2041 No paths are available on this link. Please make another
selection.
EID-2042 This span is not selectable. Only the green spans with an arrow
may be selected.
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
Refer to the error or warning message text.
For example, this error is generated from
the node view Provisioning> WDM-ANS>
tabs to indicate that the selected ring type is
not supported by the endpoints of the
circuit. Another example is the
Provisioning> VLAN tabs in card view
(Ethernet card only), where it indicates that
the back-end spanning tree protocol (STP)
disabling is not supported.
Error occurred while attempting to switch a
path protection circuit away from a span.
CTC could not delete the circuit drop.
CTC could not remove the circuit node.
The task you are trying to complete is not
supported by CTC.
There was an error during provisioning.
There was an error while adding a node.
CTC could not rename the circuit.
There was an internal error while validating
the user changes after the Apply button was
pressed. This error can occur in the Edit
Circuit dialog box or in the BLSR table in
the shelf view (rare condition).
Refer to the error message text.
Refer to the error message text.
You cannot delete the DCC/GCC link as it
is needed to access the node.
CTC cannot find an attribute for the
specified item.
The protection operation you tried to
execute is invalid.
You must select a node before performing
the task.
You must select a link that has paths
available.
Refer to the error message text.
1-5