Cisco ONS 15310-CL Troubleshooting Manual page 315

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6074 End System mode only supports one subnet.
EID-6075 Trying to remove MAT entry that does not exit.
EID-6076 Cannot {0} TARP manual adjacency entry:
{1}
EID-6077 Area address shall be 1 to 13 bytes long.
EID-6078 TDC entry with TID {0} does not exist in the table.
EID-6079 Unable to remove TDC entry with TID {0}.
Please verify that TARP is enabled.
WID-6080 Router #{0} does not have an area address in common with
router #1. Switching from IS L1/L2 to IS L1 in this case will
partition your network.
EID-6081 The limit of 10 RADIUS server entries has been reached.
EID-6082 {0} cannot be empty.
EID-6083 The entry you selected for editing has been altered by other.
Changes cannot be committed.
EID-6084 The RADIUS server entry already exists.
WID-6085 Disabling shell access will prevent Cisco TAC from connecting
to the vxWork shell to assist users.
EID-6086 Cannot change card. Card resources are in use.
EID-6087 Cannot change card. The new card type is invalid or
incompatible.
EID-6088 This line cannot be put into loopback while it is in use as a
timing source
EID-6089 Interface not found. {0}
EID-6090 Interface type not valid for operation. {0}
EID-6091 The current state of the interface prohibits this operation. {0}
EID-6092 Operation prohibited for this interface. {0}
EID-6093 Max number of Tarp Data Cache entries exceeded.
EID-6094 Max number of Manual Adjacency Table entries exceeded.
EID-6095 Invalid Ais/Squelch mode.
EID-6096 Default IP Over CLNS tunnel route is only allowed on a node
without a default static route and a default router of 0.0.0.0
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
Refer to the error message text.
CTC is removing the MAT entry.
CTC cannot add the specified adjacency
entry for reasons unknown.
The area address should not be more than 13
characters.
The specified Tunnel Identifier does not
exist.
You must enable TARP inorder to remove
the TDC entry.
Refer to the warning message text.
CTC does not allow more than 10 RADIUS
servers.
The Shared Secrets field should not be
empty.
Refer to the error message text.
Specify another RADIUS server entry.
Refer to the warning message text.
The card you are trying to remove is being
used. Cannot change the card.
Refer to the error message text.
Refer to the error message text.
CTC cannot find the specified interface.
Choose another interface.
The port is in an invalid state to set a
loopback.
CTC does not allow this operation for the
specified interface.
You have exceeded the number of
characters permitted.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
1-39