Cisco ONS 15310-CL Troubleshooting Manual page 316

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6097 The authorization key does not comply with IOS password
restrictions.
{0}
EID-6098 Default static route is not allowed when default IP Over CLNS
tunnel exists
EID-6099 You cannot create a subnet on a disabled router.
WID-6100 Disabling a router that has a provisioned subnet is not
recommended.
EID-6101 The MAT entry already exists.
WID-6102 The new card has less bandwidth than the current card. Circuits
using VT15 and higher will be deleted.
EID-6103 The TDC entry already exists.
EID-6104 APC ABORTED.
EID-6105 The 'Change Card' command is valid for MRC cards only when
port 1 is the sole provisioned port.
EID-6106 To delete all RADIUS server entries, RADIUS authentication
must be disabled.
EID-6107 The node failed to restart the TELNET service on the selected
port. Try using another unreserved port that is not being used
within the following ranges:
23, 1001-9999 (with the exception of 1080, 2001-2017, 2361,
3081-3083, 4001-4017, 4022, 4081, 4083, 5000, 5001, 7200,
9100, 9300, 9401).
EID-6108 That port is already in use.
EID-6109 Error: A section trace is active on the trunk port. The action
cannot be completed.
EID-6110 Max number of TARP requests reached.
EID-6111 The card in {0} cannot be removed because it is the protected
card.
EID-6112 Error adding shelf, {0}
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-40
Chapter 1
Description
Specify another authorization key.
Refer to the error message text.
Create the subnet on an active router.
Refer to the warning message text.
Refer to the error message text.
Refer to the warning message text.
Specify another entry for TARP Data
Cache.
Automatic Power Control is aborted.
Refer to the error message text.
Disable Radius authentication and proceed.
Refer to the error message text.
Restart a TELNET session.
Actions such as putting the port in an
incomplete state are not permitted while a
section trace is active.
You have exceeded the maximum number
of TARP requests.
Refer to the error message text.
The shelf ID specified is invalid or already
exists, the equipment does not support
multishelf, the specified shelf position is
out of range, or the specified shelf position
is already in use.
Error Messages
78-17235-01