Cisco ONS 15310-CL Troubleshooting Manual page 305

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3353 There is no such interface available.
EID-3354 Specified endpoint is in use.
EID-3355 Specified endpoint is incompatible.
EID-3357 Unable to calculate connections.
EID-3358 Optical link model does not exist for specified interface.
EID-3359 Unable to set optical parameters for the node.
EID-3361 Ring termination is in use. Error deleting ring termination
EID-3362 Error deleting ring termination.
EID-3363 No ring terminations selected.
EID-3364 Error creating ring ID.
EID-3365 OSC termination is in use.
EID-3366 Unable to delete OSC termination.
EID-3370 No optical link has been selected
EID-3371 Error while calculating automatic optical link list.
EID-3372 Attempt to access an OCHNC connection that has been
destroyed.
EID-3375 Expected span loss must be set.
EID-3376 Unable to retrieve measured span loss.
EID-3377 Wrong interface used.
EID-3378 Duplicate origination patchcord identifier.
EID-3379 Duplicate termination patchcord identifier.
EID-3380 Unable to locate host.
EID-3381 Maximum Frame size must be between {0} and {1} and may be
increased in increments of {2}.
EID-3382 Number of credits must be between {0} and {1}.
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
The interface specified is not present in
CTC.
Select another endpoint that is not in use.
Refer to the error message text.
Refer to the error message text.
Create an optical linkmodel for the
interface, and proceed.
Refer to the error message text.
You cannot delete a ring in use.
There was an error while deleting ring
termination.
You must select a ring termination.
There was an error while creating the ring
ID.
Select another optical service channel
(OSC) which is not in use.
There was an error deleting the OSC
termination.
You must select an optical link.
Refer to the error message text.
CTC destroyed an external attempt to
access an optical channel network
connection.
Refer to the error message text.
Refer to the error message text.
The interface used for the card is wrong.
The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the origination node.
The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the remote node.
Refer to the error message text.
The frame size must be in the specified
range. This can incremented by the
specified value.
The number of credits must be between the
specified values.
1-29