Cisco ONS 15310-CL Troubleshooting Manual page 300

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3237 Database Backup failed. {0}
EID-3238 Send PDIP setting on {0} is inconsistent with that of control
node {1}
EID-3239 The overhead termination is invalid
EID-3240 The maximum number of overhead terminations has been
exceeded.
EID-3241 The {0} termination port is in use.
EID-3242 An {1} exists on the selected ports.
Therefore, you must create the {0}s one by one.
WID-3243 The port you have chosen as an {0} endpoint already supports
an {1}. The port cannot support both DCCs. After the {0} is
created, verify that no EOC alarms are present and then delete
the {1} to complete the downgrade.
EID-3244 An {0} exists on the selected ports.
Therefore, you must create the {1}s one by one.
WID-3245 The port you have chosen as an {1} endpoint already supports
an {0}. The port cannot support both DCCs. After the {1} is
created, verify that no EOC alarms are present and then delete
the {0} to complete the upgrade.
EID-3246 Wizard unable to validate data: {0}
EID-3247 Ordering error. The absolute value should be {0}
EID-3248 Wrong parameter is changed: {0}
EID-3249 Invalid voltage increment value.
EID-3250 Invalid power monitor range.
EID-3251 Unable to complete requested action. {0}
EID-3252 No download has been initiated from this CTC session.
EID-3253 Reboot operation failed. {0}
EID-3254 Validation Error. {0}
EID-3255 Cannot change timing configuration, manual/force operation is
performed.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-24
Chapter 1
Description
CTC failed to backup the specified
database.
The send payload defect indicator path
(PDI-P) setting on the specified item should
be consistent with that of the specified
control node.
Refer to the error message text.
Overhead terminations have exceeded the
limit.
The specified termination port is in use.
Select another port.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
The same port can not be used by multiple
DCCs.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
The port selected as a DCC endpoint
already supports another DCC. Refer to the
warning message text.
CTC encountered an error.
The absolute value entered was wrong.
CTC changed the incorrect parameter.
Refer to the error message text.
Refer to the error message text.
CTC could not complete the specified
action.
Refer to the error message text.
Refer to the error message text.
The Cisco Transport Controller (CTC) was
unable to validate the values entered by the
user, specified by {0}. This error message is
common to several different provisioning
tabs within the CTC.
Refer to the error message text.
Error Messages
78-17235-01