Cisco ONS 15310-CL Troubleshooting Manual page 308

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-4011 Provisioning error:
{0}
EID-5000 Cannot find a valid route for tunnel change request.
EID-5001 Tunnel could not be changed.
EID-5002 Tunnel could not be restored and must be recreated manually.
EID-5003 Circuit roll failure.
{0}
EID-5004 There is already one 4F {0} provisioned on the set of nodes
involved in {1}. The maximum number of 4F {0} rings has
been reached for that node.
WID-5005 A non-zero hold-off time can violate switching time standards,
and should only be used for a circuit with multiple path
selectors.
WID-5006 Warning: Different secondary {0} node should only be used for
DRI or Open-ended path protected circuits.
WID-5007 If you change the scope of this view, the contents of this profile
editor will be lost.
WID-5008 Please make sure all the protection groups are in proper state
after the cancellation.
WID-5009 Circuit {0} not upgradable. No {1} capable {2}s are available
at node {3}.
EID-5010 Domain name already exists.
EID-5011 Domain name may not exceed {0} characters.
WID-5012 Software load on {0} does not support the addition of a node to
a 1+1protection group.
EID-5013 {0} doesn't support Bridge and Roll Feature. Please select a
different port.
EID-5014 An automatic network layout is already in progress, please wait
for it to complete for running it again.
WID-5015 {0} cannot be applied to {1}.
EID-5016 An error was encountered while attempting to provision the
{0}. {1}
EID-5017 Unable to rollback provisioning, the {0} may be left in an
INCOMPLETE state and should be manually removed.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-32
Chapter 1
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
There is already one 4F BLSR provisioned
on the set of nodes involved in the ring. The
maximum number of 4F BLSR rings has
been reached for that node.
Refer to the warning message text.
You should use different secondary end
point only for DRI or open-ended path
protected circuits.
Refer to the warning message text.
Refer to the warning message text.
No VT capable STSs are available at the
node.
Refer to the error message text.
You may have reached the maximum
number of charcters.
Refer to the warning message text.
The specified port does not support Bridge
and Roll.
You must for the automatic network layout
to complete before running it again.
You cannot apply the admin state operation,
specified by {0}, to port count, specified by
{1}.
CTC encountered an error while
provisioning the card.
You may have to remove the BLSR
manually as it was left incomplete.
Error Messages
78-17235-01