Cisco ONS 15310-CL Troubleshooting Manual page 312

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6006 Could not assign timing references:
- NE reference can only be used if timing mode is LINE.
- A BITS reference can only be used if timing mode is not
LINE.
- A line reference can only be used if timing mode is not
EXTERNAL.
EID-6008 SF BER and SD BER are not provisionable on the protect line
of a protection group.
WID-6009 If Autoadjust GFP Buffers is disabled, GFP Buffers Available
must be set to an appropriate value based on the distance
between the circuit end points.
WID-6010 If Auto Detection of credits is disabled, Credits Available must
be set to a value less than or equal to the number of receive
credits on the connected FC end point.
WID-6011 Idle filtering should be turned off only when required to operate
with non-Cisco Fibre Channel/FICON-over-SONET
equipment.
EID-6012 Could not change the retiming configuration. There are circuits
on this port.
EID-6013 NTP/SNTP server could not be changed.
{1}
EID-6014 Operation failed. The reference state is OOS.
EID-6015 Distance Extension cannot be disabled if the port media type is
FICON 1Gbps ISL or FICON 2Gbps ISL.
EID-6016 Card mode cannot be changed to Fibre Channel Line Rate if the
port media type is FICON 1Gbps ISL or FICON 2Gbps ISL.
EID-6017 The destination of a {0} route cannot be a node IP address.
EID-6018 The destination of a {0} route cannot be the same as the subnet
used by the node.
EID-6019 The destination of a static route cannot be 255.255.255.255
EID-6020 The destination of a static route cannot be the loopback network
(127.0.0.0/8)
EID-6021 The subnet mask length for a non-default route must be
between 8 and 32.
EID-6022 The subnet mask length for a default route must be 0.
EID-6023 The destination of a {0} route cannot be an internal
network{1}.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-36
Chapter 1
Description
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
You cannot change the timing configuration
on this port unless the circuits on this port
are deleted.
Refer to the error message text.
Change the Out-of-service state to Active.
Refer to the error message text.
Refer to the error message text.
A node IP address cannot be the destination
for a static route.
Refer to the error message text.
The network address such as
255.255.255.255 is not valid. Enter a valid
address.
Refer to the error message text.
Length of subnet mask must be within the
specified range.
Refer to the error message text.
The destination of a static route must not be
an internal network.
Error Messages
78-17235-01