Installing Expansion Modules In At-Sbx81Xlem Ethernet Line Cards - Allied Telesis SwitchBladex8112 Installation Manual

Chapter 7: Installing the AT-SBx81CFC960 Control Card and Ethernet Line Cards
Installing Expansion Modules in AT-SBx81XLEM Ethernet Line
Cards
142
This section contains the procedure for installing an expansion module in
the AT-SBx81XLEM Ethernet Line Card. If you did not purchase AT-
SBx81XLEM Ethernet Line Cards, skip this procedure and go to "Installing
the Ethernet Line Cards" on page 150.
Caution
You must install the expansion module before installing the AT-
SBx81XLEM Ethernet Line Card in the chassis. Attempting to install
the module when the line card is installed in the chassis will damage
the module and card. If the card is already installed in the chassis,
remove it by performing the procedure "Replacing Ethernet Line
Cards" on page 261.
Note
Please review "Guidelines to Handling the Controller and Line
Cards" on page 134 before performing this procedure.
The illustrations in the procedure show the AT-SBx81XLEM/XS8
Expansion Module. The procedure is the same for the AT-SBx81XLEM/
Q2 Module.
To install an expansion module in the AT-SBx81XLEM Ethernet Line
Card, perform the following procedure:
1. Remove the AT-SBx81XLEM Ethernet Line Card from the shipping
package. If it is missing or damaged, contact your Allied Telesis sales
representative for assistance.
Note
Store the packaging material in a safe location. You should use the
original shipping material if you need to return the unit to Allied
Telesis.
2. Carefully remove the card from the anti-static bag. Refer to Figure 73
on page 143.
Section II: Installing the Chassis