Show Ports Command - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
where
<port number> = A port number, from 1 to 8.
The show port command shows the line status (up or down), the actual upstream/downstream rates and mode of an
individual ADSL port.
24.3.21

Show Ports Command

Syntax:
192.168.1.1 adsl> show ports
The show ports command shows the line status (up or down), the actual upstream/downstream rates and the
mode of all ADSL ports.
24.3.22 Set PVC Command
Syntax:
192.168.1.1 adsl> set pvc <port number> <multiplexing mode> <tx vpi>
<tx vci> [<rx vpi> <rx vci>]
where
<port number>
<multiplexing mode> =
<tx vpi>
<tx vci>
<rx vpi>
<rx vci>
The <tx vpi> and <tx vci> settings define virtual channels for outgoing (downstream) traffic. The <rx
vpi> and <rx vci> settings define virtual channels for incoming (upstream) traffic. The <rx vpi> and
<rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx settings are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL
port.
The following example sets ADSL port 5 to use the LLC multiplexing mode, Tx VPI 8 and Tx VCI 33. The
results of this command are reflected when you use the
192.168.1.1 adsl> set pvc 5 llc 8 33
24-14
A port number, from 1 to 8.
=
Either "llc" or "vc"
The VPI setting of the ADSL port for use with a Tx based network
=
The VCI setting for the ADSL port for use with a Tx based network
=
The VPI setting for the ADSL port for use with Rx based networks
=
The VCI setting for the ADSL port for use with Rx based networks
=
show pvcs
command.
ADSL Commands