IES-1000 User's Guide
This command sets the VLAN ID to a specific port in the PVID table. To display the PVID table simply enter
this command without parameters, as shown next.
Make sure you set all bonded ports to have the same PVID.
31.3.4
SVLAN CPU Command
Syntax:
192.168.1.1 vlan1q> svlan cpu [<vid>]
where
<vid>
=
This command registers your CPU as a port member of the static VLAN with <vid>. To display the CPU
static VLAN identification, simply enter this command without parameters, as shown next.
192.168.1.1 vlan1q> svlan cpu
31.3.5
SVLAN List Command
Syntax:
192.168.1.1 vlan1q> svlan list
31-4
192.168.1.1 vlan1q> pvid
port# pvid
----- -----
1
1
2
1
3
1
4
1
5
1
6
1
7
1
8
1
9
1
Figure 31-1 Example: PVID Command Display
A VLAN ID. Valid parameter range = [1 – 4094].
IEEE 802.1QTagged VLAN Commands