Chapter 34 Remote Management; Remote Management Introduction; Management By Telnet; Snmp Access Configuration - ZyXEL Communications IES-1000 User Manual

34.1

Remote Management Introduction

More often than not, you will have the IES-1000 located remotely making its remote management features very
useful. See the web configurator chapter on SNMP for background information on SNMP.
34.2

Management by Telnet

After you have set up the IP parameters and connected the IES-1000 to the network, you can manage it remotely
with telnet. You can use any telnet client that you find convenient. The configuration procedures with telnet are
exactly the same as those using the direct connection via the console port. The default password for a telnet
session is "1234". Although telnet will work while the console port is being used, only one telnet session is
allowed at a time.
34.3

SNMP Access Configuration

To control access to the agent in the network module, use the access commands in the SNMP subsystem. Note
that "community" is SNMP's terminology for password. After configuring the SNMP access parameters, save the
configuration to the nonvolatile memory with the config save command. The default write community string
is "1234", and the default read community string is "public".
34.3.1 SNMP Access Read/Write Command
Syntax:
access <read | write> <community> [<IP addr>]
where
<read | write> =
<community>
[<IP addr>]
This command allows read-only or read-write access. If the IP address is specified, access is allowed for the
manager station with that address only.
Remote Management
This chapter shows you how to manage the IES-1000 remotely.
Specifies read-only/read-write permission.
= The password needed to access the SNMP agent on the network module.
= The optional IP address of the allowed SNMP manager.
Remote Management
IES-1000 User's Guide
Chapter 34
34-1