Dsl Led(S) Turn On And Off; Data Rate; Port Bonding; Configured Settings - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
21.3

DSL LED(s) Turn On and Off

A DSL LED turns on and off intermittently.
STEPS
1 Check the IES-1000's diagnostic screen.
2 Connect a DSL modem directly to the DSL port of the IES-1000 using a different telephone wire.
If the DSL LED still turns on and off repeatedly, contact the distributor.
21.4

Data Rate

The SYNC-rate is not the same as the configured rate.
STEPS
1 Connect the DSL modem or router directly to the DSL port of the IES-1000 using a different
telephone wire.
2 If the rates match, the quality of the telephone wiring that connects the subscriber to the IES-1000
may be limiting the speed to a certain rate.
If they do not match when a good wire is used, contact the distributor.
21.5

Port Bonding

Refer to the Troubleshooting chapter in the part on commands.
21.6

Configured Settings

The IES-1000's configured settings do not take effect.

Table 21-5 Troubleshooting the Network Module's Configured Settings

Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000 loses these
changes if it is turned off or loses power, so use the Config Save link on the navigation panel to the left to
save your changes to the non-volatile memory when you are done configuring. If this does not work, contact
the distributor.
21.7

Password

I forgot the password to my IES-1000.
See the chapter on firmware upload and recovery in the Commands part.
21-2

Table 21-3 Troubleshooting a Non-Constant DSL LED

Table 21-4 Troubleshooting the SYNC-rate

CORRECTIVE ACTION

Table 21-6 Troubleshooting the Password

CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
Troubleshooting