Delete N-Wire Group Command - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
G.SHDSL ports one through four do not need to be set to be the same end of the connection as G.SHDSL ports
five through eight. For example, G.SHDSL ports one through four could be set to be STU-C while G.SHDSL
ports five through eight are set to be STU-R.
The following example sets an STU-R port bonding group named "r1" for ports 3 to 6.
192.168.1.1 gshdsl> set bondr r1 3-6
Make sure you set all of the bonded ports to have the same PVID see section 31.3.3 PVID Command.
If the ports are enabled and you change them from central side to remote side or vice versa (all ports are set to the
central side by default), the system will take a few moments to process the change. If the ports are not enabled, the
processing occurs when you enable them. During this processing the system appears to be hanging.
25.3.26 Port Bonding for 4-wire Groups Examples
This example creates three 4-wire mode STU-R groups and then bonds them together.
This line sets an STU-R 4-wire mode (2 ports) group with the name "N-wire-A" for ports 7 and 8.
192.168.1.1 gshdsl> set nwirer 4w N-wire-A 4
This line sets an STU-R 4-wire mode (2 ports) group with the name "N-wire-B" for ports 5 and 6.
192.168.1.1 gshdsl> set nwirer 4w N-wire-B 3
This line sets an STU-R 4-wire mode (2 ports) group with the name "N-wire-C" for ports 3 and 4.
192.168.1.1 gshdsl> set nwirer 4w N-wire-C 2
This line sets an STU-R port bonding group named "r1" for the "N-wire-A", "N-wire-B" and "N-wire-C" n-wire
groups.
192.168.1.1 gshdsl> set bondr 4w r1 2-4
25.3.27 Port Bonding for 8-wire Groups Examples
This example creates two 8-wire mode STU-R groups and then bonds them together.
This line sets an STU-R 8-wire mode (4 ports) group with the name "N-wire-A" for ports 1 to 4.
192.168.1.1 gshdsl> set nwirer 8w N-wire-A 1
This line sets an STU-R 8-wire mode (4 ports) group with the name "N-wire-B" for ports 5 to 8.
192.168.1.1 gshdsl> set nwirer 8w N-wire-B 2
This line creates an STU-R port bonding group named "r1" for the "N-wire-A" and N-wire-B" n-wire groups.
192.168.1.1 gshdsl> set bondr 8w r1 1 2
25.3.28

Delete N-wire Group Command

Syntax:
25-14 G.SHDSL Commands