System Error Log Commands; Errlog Display Command; Errlog Clear Command - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
This command sets the UNIX server IP address. If <server IP>=0.0.0.0 (default), then logs will be
dropped (not be sent).
23.6

System Error Log Commands

The system error log will record error events locally to the IES-1000 memory. You may clear or display these logs
using the commands listed in this section.
The following lists some examples of logs that the system error log can record. Please refer to the web
configurator Diagnostic chapter for log details.
ADSL link on (port number, sequence number, rate,
noise margin, attenuation)
ADSL OVER_HEAT_ACTIVE (temperature)
G.SHDSL link on (port number, sequence number,
rate, noise margin, attenuation)
G.SHDSL OVER_HEAT_ACTIVE (temperature)
Console session begin
Telnet session begin
Incorrect telnet password
FTP session begin
Incorrect FTP password
FTP image error (reason)
System reboot
23.6.1

Errlog Display Command

Syntax:
192.168.1.1 sys> errlog display
This command displays the system error log.
Upgrade firmware or restore the configuration file through FTP or the web configurator to store
23.6.2

Errlog Clear Command

Syntax:
192.168.1.1 sys> errlog clear
This command clears the system error log.
If you clear a log (using the errlog clear command), you may not view it again.
23-6
ADSL link down (port number, sequence number, noise
margin, attenuation)
ADSL OVER_HEAT_RELEASE (temperature)
G.SHDSL link down (port number, sequence number,
noise margin, attenuation)
G.SHDSL OVER_HEAT_RELEASE (temperature)
Console session end
Telnet session end
Insecure telnet access (IP address)
FTP session end
Insecure FTP access (IP address)
FTP receive file OK (file name)
an error log in non-volatile memory.
System Commands