Figure 11-4 Ethernet Port Setup; Table 11-5 Ethernet Port Setup - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
When auto-negotiation is turned on, the Ethernet port of the IES-1000 negotiates with the peer Ethernet port on
the Ethernet cable automatically to determine the optimal connection speed and duplex mode. If the peer Ethernet
port does not support auto-negotiation or turns off this feature, the IES-1000 determines the connection speed by
detecting the signal on the cable and using half duplex mode. When the IES-1000's auto-negotiation is turned off,
the Ethernet port uses the pre-configured speed and duplex mode settings when making a connection, thus
requiring you to check the settings of the peer Ethernet port in order to connect.
11.9.1 Ethernet Port Setup Screen
Click 0 in the Port Setup screen to open this screen.
The following table describes this screen.
LABEL
Port Setup Click this link to go to the Port Setup screen.
Mode Use the drop-down list box to select a speed and duplex setting for the Ethernet port. In
10/100Mbps Fast Ethernet, the speed can be 10Mbps or 100Mbps. The duplex mode can be
Half (meaning traffic is transmitted in one direction at a time) or Full (meaning traffic is
simultaneously transmitted in both directions). Select Auto to have the Ethernet port auto-
negotiate with a peer to obtain the connection speed and duplex mode.
Default 802.1p Type the priority value (0 to 7) to add to incoming frames without a (802.1p) priority tag.
Priority
11-8

Figure 11-4 Ethernet Port Setup

Table 11-5 Ethernet Port Setup

DESCRIPTION
ADSL Module Port Setup