AES-100 User's Guide
<upstream speed> =
<downstream speed> =
<oper mode> =
The
command sets the same maximum upstream/downstream speeds and the mode, or standard, for
set ports
all ADSL ports. Note that the upstream speed must be less than or equal to the downstream speed.
The mode parameter specifies the standard that the ports are allowed. When set to auto, the AES-100 follows
whatever mode is set on the other end of the line.
When the mode is set to auto and the negotiated mode is G.lite, if the configured speeds exceed those
allowed by G.lite, the actual speeds are governed by G.lite, regardless of the configured numbers.
4.4.14 Show Port Command
Syntax:
show port <port number>
where
<port number> = port number, from 1 to 8
The show port command shows the line status (up or down), the actual upstream/downstream speeds and mode of
an individual ADSL port.
4.4.15 Show Ports Command
Syntax:
show ports
The
command shows the line status (up or down), the actual upstream/downstream speeds and the
show ports
mode of all ADSL ports.
4-8
Maximum ADSL upstream speed in Kbps.
Maximum ADSL downstream speed in Kbps.
Operational mode; the available choices are glite, gdmt or auto.
ADSL Configuration