ZyXEL Communications IES-1000 User Manual page 122

IES-1000 User's Guide
LABEL
Available Ports When you select a 2-wire mode, the screen displays the available ports (those that are not
/Available members of an n-wire group or another port bonding group). Select the member ports for this
Groups port bonding group. Configure the groups on both ends of a connection with the same number
of ports.
When you select 4-wire or 8-wire in the Mode field, the screen displays the available 4 or 8-
wire groups. You must have already configured the 4 or 8-wire groups in the Add G.SHDSL
N-wire Group screen and the groups cannot be members of another port bonding group.
Select the member groups for this port bonding group. Configure the groups on both ends of a
connection with the same number of 4 or 8-wire groups.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link in the
navigation panel on the left to save your changes to the non-volatile memory when you are
done configuring.
Reset Click Reset to begin configuring this screen afresh.
12-12
Table 12-7 Add G.SHDSL Port Bonding
DESCRIPTION
G.SHDSL Module Port Setup