Ip Setup Screen; Figure 10-22 Ip Setup; Table 10-19 Ip Setup - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
LABEL
Port Number This is the port's name.
Enter a VLAN ID number for the port. The valid range is 1-4094. You cannot configure more
VLAN ID
than one port to use the same VLAN ID.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to the left to save your changes to the non-volatile memory when you are
done configuring.
Reset Click Reset to begin configuring this screen afresh.
10.6

IP Setup Screen

The IES-1000 needs an IP address for it to be managed over the network. The factory default IP address is
192.168.1.1. The subnet mask specifies the network number portion of an IP address. The factory default subnet
mask is 255.255.255.0. The default gateway specifies the IP address of the default gateway (next hop) for
outgoing traffic. The default gateway is specified as 192.168.1.254.
Click IP Setup in the navigation panel to open the IP Setup screen.
Use this screen to configure the IP address of the IES-1000.
The following table describes this screen.
LABEL
IP Address Enter the IP address of the IES-1000 in dotted decimal notation, for example 192.168.1.1.
IP Subnet Enter the IP subnet mask of your IES-1000 in dotted decimal notation, for example
Mask 255.255.255.0.
10-22
Table 10-18 Bridge Fast Mode VLAN ID Setup

Figure 10-22 IP Setup

Table 10-19 IP Setup

DESCRIPTION
DESCRIPTION
Getting Started Screens