Show Port Command - ZyXEL Communications IES-1000 User Manual

The mode parameter specifies the standard that this port is allowed. When set to auto, the AAM1008 follows
whatever mode is set on the other end of the line. Annex A refers to ADSL over POTS and Annex B refers to
ADSL over ISDN.
When the mode is set to auto and the negotiated mode is G.lite, if the configured rates exceed
those allowed by G.lite, the actual rates are governed by G.lite, regardless of the configured
An example is shown next.
192.168.1.1 adsl> set port 4 gold auto
This command sets ADSL port 4 to have the gold profile. The results of this command are reflected when you use
the command.
list profiles
24.3.19 Set Ports Command
Syntax:
192.168.1.1 adsl> set ports <profile name> <oper mode>
where
<profile name> = The profile that will define the settings of this port.
<oper mode>
The set ports command assigns a specific profile to all of the ADSL ports and sets all of the ports to one
mode, or standard. The profile defines the maximum and minimum upstream/downstream rates, the target
upstream/downstream signal noise margins, and the maximum and minimum upstream/downstream acceptable
noise margins of all the ADSL ports.
The mode parameter specifies the standard that this port is allowed. When set to auto, the AAM1008 follows
whatever mode is set on the other end of the line.
An example is shown next.
192.168.1.1 adsl> set ports gold auto
This command sets all of the ADSL ports to have the gold profile. The results of this command are reflected when
you use the
list profiles
When the mode is set to auto and the negotiated mode is G.lite, if the configured rates exceed
those allowed by G.lite, the actual rates are governed by G.lite, regardless of the configured
24.3.20

Show Port Command

Syntax:
show port <port number>
ADSL Commands
numbers.
= Operational mode. Choose from glite, gdmt, t1413 or auto for Annex
A. Choose from anxb, etsi or auto for Annex B.
command.
numbers.
IES-1000 User's Guide
24-13