Figure 25-1 List Port Command Example - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
where
<Port>
<Sp>
<NM>
<ATTEN>
<ES>
<SES>
<LOSWS>
<UAS>
<downN>
25.3.8 List Port Command
Syntax:
192.168.1.1 gshdsl> list port <port #>
where
<port #>
This command displays information about the line speed, state and the line rate parameter of a G.SHDSL port.
An example is shown next.
192.168.1.1 gshdsl> list port 8
Port Speed (Kbps)
Cmax/Cmin/Act
----+---------------+---------------+--------+-----------+--------------
1 2304/ 192/
2 2304/ 192/
3 2304/ 192/
4 2304/ 192/
5 2304/ 192/
6 2304/ 192/
7 2304/ 192/
8 2304/ 192/
where
Cmax
Cmin
Act
25-4
=
The port number on the SAM1008.
=
The line rate. If Sp=0, then the connection is down.
= Noise Margin. The noise margin in decibels.
= Attenuation. The loop attenuation in decibels.
= Errored Second. The total number of one-second intervals when one or more CRC
errors are found.
= Severely Errored Second. The total number of one-second intervals when at least fifty
CRC errors are found.
= Loss of Sync Word Failure Second. Displays the total number of one-second intervals
when one or more SHDSL LOSW errors are found.
=
Unavailable Second. The total number of one-second intervals when the G.SHDSL
line is unavailable.
= The number of times the G.SHDSL line has been dropped.
= The port number, from 1 to 8
Mode
- Normal
- 2-wireC
- 2-wireC
- 2-wireC
- Normal
- Normal
- Normal
- 2-wireC

Figure 25-1 List Port Command Example

= Configured maximum line speed in Kbps. The maximum G.SHDSL line speed you
configured. For details about configuring this parameter see section 25.3.15.
=
This is the configured minimum line speed in Kbps for this port. The minimum
G.SHDSL line speed you configured.
=
The actual G.SHDSL line speed in Kbps.
Bonding PSD region State
No annexB Disabled/Down
Yes annexB Disabled/Down
Yes annexB Disabled/Down
Yes annexB Disabled/Down
No annexB Disabled/Down
No annexB Disabled/Down
No annexB Disabled/Down
Yes annexB Disabled/Down
G.SHDSL Commands