Figure 6-6 Aam1008 Installation Overview - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
You can also use RJ-11 connectors on both ends of the telephone cables connect directly to an
ADSL modem(s) or patch panel. This chapter discusses connections using MDFs.
6.4.1 Typical Scenarios
Your existing telephone wiring usually depends on your region. Here are descriptions of three typical installation
scenarios. See the Notes About MDFs (Main Distribution Frames) for more information about MDFs. Use
telephone wires with RJ-11 jacks on one end (follow the pin assignments shown in the appendices) for connecting
to the AAM1008.
6.4.2 Installation Scenario A
You want to install the AAM1008 network module in an environment where there are no previously installed
MDFs. There is no phone service and you want to install the AAM1008 for data-access only. No connections from
the CO ports are necessary.
You may connect using an MDF or attach RJ-11 connectors to the non-AAM1008 side of the telephone wire and
then connect to ADSL modem directly.
6-6

Figure 6-6 AAM1008 Installation Overview

Hardware Connections