Before you make your hardware connections, make sure that your IES-1000 is safely and securely positioned.
6.1
Front Panel Connections
All connections are made on the front panel of the IES-1000. The following figure shows the front panel
connections of the SAM1008. Connect A to a power source. B is an Ethernet switch. Connect C to the users. D is
a local management computer. A more detailed discussion follows. Connections for the AAM1008 are the same
except for the DSL ports (see 6.4 for details).
6.2
Console Port
For the initial configuration, you need to use terminal emulator software on a computer and connect it to a network
module through the console port. Connect the mini-RJ-11 end of the console cable to the console port of the
network module. Connect the other end to a serial port of your computer. After the initial setup, you can modify
the configuration remotely through Telnet connections.
Hardware Connections
This chapter shows you how and where to make hardware connections.
Figure 6-1 SAM1008 Front Panel Connections Overview
Hardware Connections
IES-1000 User's Guide
Chapter 6
6-1