Chapter 37 Troubleshooting; Shdsl Or Adsl Led(S); Data Transmission; Table 37-1 Troubleshooting The Dsl Led(S) - ZyXEL Communications IES-1000 User Manual

This chapter covers potential problems and possible remedies. After each problem description, some
37.1

SHDSL or ADSL LED(s)

An SHDSL or ADSL LED is not on.
STEPS
1 Make sure the DSL port is enabled and properly configured (refer to Chapter 25 and Chapter 24 ).
2 Connect a DSL modem directly to the DSL port of the network module using a different telephone wire.
If the LED turns on, go to step 4.
3 Check to see that the settings in the DSL modem or router match those of the DSL port (refer to
Chapter 25 and Chapter 24 ).
If the DSL LED stays off, there may be a problem with the port. Contact the distributor.
4 Take the DSL modem to the subscriber's location.
If the DSL LED stays off, check for a problem with the telephone wiring that connects to the subscriber.
37.2

Data Transmission

The SHDSL or ADSL LED is on, but data cannot be transmitted.
STEPS
1 Check to see that the VPI/VCI settings in the subscriber's DSL modem or router match those in the
network module (refer to sections 25.3.19 and 24.3.24). Also make sure that it is using RFC 1483
encapsulation, bridge mode and LLC- based multiplexing.
2 Make sure that the network module's IP settings are configured properly (refer to Chapter 33 ).
3 Check the VLAN configuration of the network module (refer to Chapter 28 ).
4 Check the Ethernet type filter configuration (refer to 28.5.6).
5 Check the IEEE 802.1X port-based authentication configuration (refer to 30.2.3).
6 Ping the network module from the subscriber's computer.
7 If you cannot ping, connect a DSL modem to a DSL port (that is known to work) on the same network
module.
If the DSL modem or router works with a different DSL port, there may be a problem with the original
port. Contact the distributor.
8 If using a different port does not work, try a different DSL modem or router with the original port.
Troubleshooting
steps are provided to help you to diagnose and to solve the problem.

Table 37-1 Troubleshooting the DSL LED(s)

CORRECTIVE ACTION

Table 37-2 Troubleshooting Data Transmission

CORRECTIVE ACTION
IES-1000 User's Guide
Chapter 37
Troubleshooting
37-1