Show Ports Command - ZyXEL Communications IES-2000 User Manual

The command shows the line status (up or down), the actual upstream/downstream rates and mode of
show port
an individual ADSL port.
7.5.20

Show Ports Command

Syntax:
192.168.1.1 adsl> show ports
The command shows the line status (up or down), the actual upstream/downstream rates and the
show ports
mode of all ADSL ports.
7.5.21 Set PVC Command
Syntax:
192.168.1.1 adsl> set pvc <port number> <multiplexing mode> <tx vpi> <tx vci>
[<rx vpi> <rx vci>]
where
<port number>
<multiplexing mode>
<tx vpi>
<tx vci>
<rx vpi>
<rx vci>
The command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL
set pvc
port.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the
rx .settings are not configured.
7.5.22 Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx
vci>]
where
<multiplexing mode>
<tx vpi>
<tx vci>
ALC1024 Specific Commands
A port number, from 1 to 24.
=
Either or
= llc vc.
The VPI setting of the ADSL port for use with a TX based network.
=
The VCI setting for the ADSL port for use with a TX based network.
=
The VPI setting for the ADSL port for use with Rx based networks.
=
The VCI setting for the ADSL port for use with Rx based networks.
=
either "llc" or "vc"
=
The VPI setting of the ADSL port for use with a TX based network.
=
The VCI setting for the ADSL port for use with a TX based network.
=
IES-2000/3000 User's Guide
7-13