Figure 20-2 Dsl Line Diagnostic; Table 20-4 Dsl Line Diagnostic - ZyXEL Communications IES-1000 User Manual

LOG MESSAGE
THERMO RELEASE OVER
RANGE: dev:<device id>
value:<temp>
Insecure Telnet From
<ip addr>
Incorrect Telnet
Password
Telnet Session Begin
Telnet Session End
20.3.2 DSL Line Diagnostic Screen
Click DSL in the Diagnostic screen to open the DSL Line Diagnostic screen.
Use this screen to check the module's DSL chip via Local Loopback or connections via OAM F5 tests.
LABEL
Diagnostic Click this link to go to the network module's Diagnostic screen.
Diagnostic
Table 20-3 Log Messages
TYPE
WARN The temperature detected in the network module has come back to
normal.
<temp>
WARN Someone tried to start a Telnet session from the listed IP address
and it did not match any of the configured secured client IP
addresses.
WARN Someone attempted to use the wrong password to start a Telnet
session.
INFO A Telnet session has started.
A Telnet session has terminated.
INFO

Figure 20-2 DSL Line Diagnostic

Table 20-4 DSL Line Diagnostic

DESCRIPTION
- temperature when the entry was logged
DESCRIPTION
IES-1000 User's Guide
20-5