Figure 24-4 Linerate Command Example; Line Delay Command - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
An example is shown next.
192.168.1.1 adsl> linerate 7
Current Active Rates:
AS0 downstream rate
AS1 downstream rate
LS0 upstream
LS1 upstream
Down/up stream Margin
Down/up stream Attenuation
Attainable Down/up stream Rate
These results contain the current downstream and upstream operating values (SHOWTIME) for the requested line,
the latest available downstream and upstream margins, channel attenuation and the maximum attainable rate.
Downstream and upstream margins must both be at least 6 dB. The initial downstream and upstream margins are
first set during training. The upstream margin is recalculated every 15 seconds during "show time" at the ATU-C
and the downstream margin updates every 15 seconds during "show time" by using EOC messaging.
Information obtained prior to training to steady state transition will not be valid or will be old information.
24.3.10

Line Delay Command

Syntax:
192.168.1.1 adsl>
value> <Symbol|MilliSec>]
where
<
ports|port number
<downstream value>
<upstream value>
<Symbol|MilliSec>]
Sets or displays the maximum interleave latency delay.
24.3.11 List Port Command
Syntax:
192.168.1.1 adsl> list port <port number>
where
<port number> = A port number, from 1 to 8.
The list port command shows the configured maximum upstream/downstream rates, the mode (or standard),
and enable/disable state of an individual ADSL port.
24-8
rate
rate

Figure 24-4 Linerate Command Example

ldly <ports|port number> [<downstream value> <upstream
> = All of the ADSL ports or a single port, from 1 to 8.
=
The downstream interleave latency delay (0..255)
=
The upstream interleave latency delay (0..255) milliseconds.
=
Set the measurement of the interleave delay to use with symbols or
milliseconds.
: 2048 Kbps
: 0 Kbps
: 512 Kbps
: 0 Kbps
: 31/22 dB
: 0/ 0 dB
: 11456/ 1344 Kbps
ADSL Commands