Figure 12-4 G.shdsl Add Profile; Table 12-4 G.shdsl Add Profile - ZyXEL Communications IES-1000 User Manual

LABEL
Port Setup Click this link to go to the Port Setup screen.
Profile Name When editing a profile, this is the name of this profile. When adding a profile, type a name for
the profile.
PSD Region Select the Power Spectral Density (PSD) region for this profile (Annex A for North America or
Annex B for Europe).
Min Rate (Kbps) Select a minimum speed from 192K to 2304K. Do not configure a minimum speed greater than
the maximum speed.
Max Rate (Kbps) Select a maximum speed from 192K to 2304K. Do not configure a maximum speed less than
the minimum speed.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000 loses
these changes if it is turned off or loses power, so use the Config Save link on the navigation
panel to the left to save your changes to the non-volatile memory when you are done
configuring.
Reset Click Reset to begin configuring this screen afresh.
12.8.2 Ethernet Port Setup Screen
Ethernet Port Setup in the SAM1008 module is the same as in the AAM1008 module (see section 11.9).
12.8.3 G.SHDSL Port Setup Screen
Click a G.SHDSL port in the Port Setup screen to open this screen.
G.SHDSL Module Port Setup

Figure 12-4 G.SHDSL Add Profile

Table 12-4 G.SHDSL Add Profile

DESCRIPTION
IES-1000 User's Guide
12-7