Removing and Installing Network Modules
Each IES-1000 accommodates up to two network modules. Remove and install modules via the front of the IES-
1000. The figure below shows the front view of a SAM1008 network module; the procedures for removing and
installing AAM1008 network modules are the same.
5.1
Removing a G.SHDSL SAM1008 Network Module
Loosen the two screws on the front panel that secure the module to the chassis by turning them counter-
Step 1.
clockwise as shown next.
Gently pull the network module out of the chassis as shown next.
Step 2.
Removing and Installing Network Modules
This chapter shows you how to remove and install network modules.
Figure 5-1 IES-1000 G.SHDSL SAM1008 Network Module
Figure 5-2 Loosen Module Screws
IES-1000 User's Guide
Chapter 5
5-1