Figure 10-16 Add Dhcp Server; Table 10-14 Add Dhcp Server - ZyXEL Communications IES-1000 User Manual

LABEL
Bridge Setup Click this link to go to the Bridge Setup screen.
DHCP Relay Click this link to go to the DHCP Relay Setup screen.
Setup
Type the IP address of the DHCP server to which the Integrated Ethernet Switch should
IP Address
relay DHCP client TCP/IP configuration requests.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to the left to save your changes to the non-volatile memory when you are
done configuring.
Reset Click Reset to begin configuring this screen afresh.
10.5.12 IEEE 802.1X Authentication Introduction
IEEE 802.1X is an extended authentication protocol
In User Service, RFC 2138, 2139) for centralized user profile and accounting
RADIUS server.
RADIUS
RADIUS (Remote Authentication Dial-In User Service) authentication is a popular protocol used to authenticate
users by means of an external server instead of (or in addition to) an internal device user database that is limited to
1
At the time of writing, only Windows XP and Windows 2000 with service pack four of the Microsoft operating systems
supports it. See the Microsoft web site for information on other Windows operating system support. For other operating
systems, see its documentation. If your operating system does not support IEEE 802.1X, then you may need to install IEEE
802.1X client software.
2
Not available at the time of writing.
Getting Started Screens

Figure 10-16 Add DHCP Server

Table 10-14 Add DHCP Server

DESCRIPTION
1
that allows support of RADIUS (Remote Authentication Dial
IES-1000 User's Guide
2
management on a network
10-17