10/100M Auto-Sensing Ethernet - ZyXEL Communications IES-1000 User Manual

LABEL
Min Rate (Kbps) Type the minimum upstream transfer rate (from 32 to 1024 Kbps) for this profile. Configure the
minimum upstream transfer rate to be less than the maximum upstream transfer rate.
Latency Configure this field when you set the Latency Mode field to interleave. Type the number of
Delay(ms) milliseconds (0-255) of interleave delay to use for upstream transfers. It is recommended that
you configure the same latency delay for both upstream and downstream.
Max SNR (db) Type the maximum upstream signal to noise margin (0-31 dB).
Min SNR (db) Type the minimum upstream signal to noise margin (0-31 dB). Configure the minimum
upstream signal to noise margin to be less than or equal to the maximum upstream signal to
noise margin.
Target SNR (db) Type the target upstream signal to noise margin (0-31 dB). Configure the target upstream
signal to noise margin to be greater than or equal to the minimum upstream signal to noise
margin and less than or equal to the maximum upstream signal to noise margin.
Down Stream The following parameters relate to downstream transmissions.
Max Rate (Kbps) Type a maximum downstream transfer rate in Kbps for this profile. Speeds from 32 to 8160
(Kbps) are supported.
Min Rate (Kbps) Type the minimum downstream transfer rate (from 32 to 8160 Kbps) for this profile. Configure
the minimum downstream transfer rate to be less than the maximum downstream transfer rate.
Latency Configure this field when you set the Latency Mode field to interleave. Type the number of
Delay(ms) milliseconds (0-255) of interleave delay to use for upstream transfers. It is recommended that
you configure the same latency delay for both upstream and downstream.
Max SNR (db) Type the maximum downstream signal to noise margin (0-31 dB).
Min SNR (db) Type the minimum downstream signal to noise margin (0-31 dB). Configure the minimum
downstream signal to noise margin to be less than or equal to the maximum downstream
signal to noise margin.
Target SNR (db) Type the target downstream signal to noise margin (0-31 dB). Configure the target downstream
signal to noise margin to be greater than or equal to the minimum downstream signal to noise
margin and less than or equal to the maximum downstream signal to noise margin.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000 loses
these changes if it is turned off or loses power, so use the Config Save link on the navigation
panel to the left to save your changes to the non-volatile memory when you are done
configuring.
Reset Click Reset to begin configuring this screen afresh.
11.9

10/100M Auto-Sensing Ethernet

The IES-1000 supports 10/100Mbps auto-negotiating Ethernet. There are two factors related to the connection of
two Ethernet ports: speed and duplex mode. In a 10/100Mbps fast Ethernet, the speed can be 10Mbps or 100Mbps
and the duplex mode can be half duplex or full duplex. The auto-negotiation capability makes one Ethernet port
able to negotiate with a peer automatically to obtain the optimal connection speed and duplex mode.
ADSL Module Port Setup
Table 11-4 ADSL Add Profile
DESCRIPTION
IES-1000 User's Guide
11-7