Figure 24-5 List Profiles Command Example - ZyXEL Communications IES-1000 User Manual

24.3.15 List Profiles Command
Syntax:
192.168.1.1 adsl> list profiles
The list profiles command displays all of the ADSL ports and that profile is assigned to each one.
An example is shown next. This display shows that there are two profiles (DEFVAL and debug) and that port 4
belongs to the debug profile while ports 1, 2, 3, 5, 6, 7 and 8 belong to the DEFVAL profile.
192.168.1.1 adsl> list profiles
Profile 1 : DEFVAL
Profile 2 : debug
Port 1, Profile : DEFVAL
Port 2, Profile : DEFVAL
Port 3, Profile : DEFVAL
Port 4, Profile : debug
Port 5, Profile : DEFVAL
Port 6, Profile : DEFVAL
Port 7, Profile : DEFVAL
Port 8, Profile : DEFVAL
24.3.16 Show Profile Command
Syntax:
192.168.1.1 adsl> show profile <name>
where
<name> = A profile name.
The show profile command displays the settings of an ADSL profile.
An example is shown next. This display shows that the maximum downstream transmission rate is set to 8000
kbps and the maximum upstream transmission rate is set to 800 kbps. The ConfProfileRowStatus displays
active; this means that the profile is available for use. It does not mean that the profile has been applied to any
of the ports. Please refer to the set port command for information on assigning profiles to ports or the list
profiles command for information on displaying the names of all of the profiles and which profile is assigned
to each port.
ADSL Commands

Figure 24-5 List Profiles Command Example

IES-1000 User's Guide
24-11