Doosan DX60R Shop Manual page 725

5. Tighten adjusting bolt.
NOTE:
After completing all assembly procedures
tighten down adjusting bolt to torque of 9.8 Nm.
6. Assembling of pickings.
7. Place gasket on the housing surface and assemble the
upper and lower halves of the pump together.
NOTE: Be careful not to let aligning pins drop while
assembling.
8. Install cover.
(M14 x 40, 2 each) (M14 x 75, 1 each)
NOTE:
Torque 150 - 180 Nm (15 - 18 kg•m) 108.50 -
130 ft lb).
9. Install O-rings in cover.
Main Pump
Figure 88
Figure 89
Figure 90
Figure 91
SP001488
Page 45