Doosan DX60R Shop Manual page 590

Cover Removal
1. Turn the work bench so cover (8) is on top.
2. Paint match marks on cover (8) and hub (1).
3. Look into the seem to locate the gap of ring (18). Remove
ring (18) using a steel rod.
Be careful when removing the ring. You could become
injured if the tip of the pliers comes out of the hole of
the retaining ring, and the retaining ring jumps out.
4. In case of difficulty to remove the ring following the above
method, try the following method.
A. Look into the seem to locate the gap of ring (18).
Make a punch mark on hub (1) at a point about
20 mm (0.79 in) from the ring end in circular
direction and 5 mm (0.1969 in) from the end face of
the hub.
B. Using an electric drill, make a 2 mm (0.079 in)
diameter hole at a punch mark.
NOTE: Be sure to center the drill on the punch mark,
and keep drilling until the ring starts rising. After
drilling clear through the wall of the hub, be sure
to wipe off the chips completely.
C. Insert the steel rod into the drilled hole and push the
ring out.
Be careful when removing the ring. You could
become injured if the tip of the pliers comes out
of the hole of ring, and the ring jumps out.
Travel Motor
Page 32
CAUTION
CAUTION
Figure 33
Figure 34
Figure 35
Figure 36
SP001686