Doosan DX60R Shop Manual page 625

Cover Assembly
1. Fill the reduction gear with the specified quantity of
lubrication oil.
NOTE:
Lubricating oil: 1 liter (0.26 U.S. gal.)
2. Fit the O-ring (29) to the cover (8).
NOTE:
Apply grease to the O-ring (29).
3. Place the cover (8) on the hub (1), make sure the match
mark is in the same position as it was disassembled. After
positioning the cover, force it into the hub by lightly
hammering with a plastic hammer on and around its rim.
4. Install the ring (18) into the hub (1).
5. Fit the O-ring (36) to the plugs (33). Tighten plugs (33)
with the specified torque to the cover (8).
NOTE:
Tightening torque: 6 ±1 kgf•m (58.8 ±9.8 Nm)
(43 ±7 ft lb)
Travel Motor
Figure 142
Figure 143
Figure 144
Figure 145
SP001686
Page 67