Doosan DX60R Shop Manual page 594

Removing Parts from the Rear Flange
1. Lay removed rear flange on the workbench, with its inner
face up.
2. Remove timing plate (109) from rear flange (201).
NOTE:
The timing plate might be found stuck to mating
face of the rear flange. To separate timing plate,
insert a flat bar into groove of rear flange and
raise the timing plates slowly. Never try to pry
timing plate off with a sharp or pointed tool or
the precision finished mating faces will suffer
costly damaged.
3. Pull out ball bearing (150) from rear flange (201).
4. Pull out two parallel pins (241) from rear flange (201).
Travel Motor
Page 36
Figure 48
Figure 49
Figure 50
SP001686