Doosan DX60R Shop Manual page 403

Starter Motor
Shock Hazard!
Turn off the battery switch (if equipped) or disconnect the
negative battery cable before servicing the electrical
system.
Check the electrical harnesses for cracks, abrasions, and
damaged or corroded connectors. Always keep the
connectors and terminals clean.
Failure to comply could result in death or serious injury.
NOTE: While starter motor design varies between models,
the basic repair procedures are the same. The
following procedures are typical and may differ from
the stater being serviced.
Removal of Starter Motor
1. Disconnect the battery cables at the battery, negative (-)
cable first.
2. Remove the electrical wires from the magnetic switch
assembly.
3. Remove the starter mounting bolts (1, Figure 343).
Remove the starter motor from the flywheel housing.
Disassembly of Starter Motor
1. Loosen the M8 nut from the magnetic switch (solenoid)
assembly (Figure 344). Disconnect the wire from the
magnetic switch.
Engine
WARNING
Figure 342
Figure 343
Figure 344
FG009151
SP001693
Page 223