Doosan DX60R Shop Manual page 438

5. Reinstall the flat washer (4, Figure 414), lock washer (3,
Figure 414), and nut (2, Figure 414). Tighten the nut to the
specified torque.
6. Reinstall the rear cap (1, Figure 414).
Installation of Dynamo
1. Position the dynamo on the gear case. Loosely reinstall
the nut (2, Figure 415) on the gear case stud and the V-
belt adjuster bolt (1, Figure 415).
2. Reconnect the dynamo output wire connector.
3. Reinstall the V-belt. Tighten the V-belt to the proper
tension as described in See "" on page -70.
4. Start the engine. Listen for any unusual sounds from the
alternator.
Do not operate the engine if the alternator is producing
unusual sounds.
Damage to the alternator will result.
5. Verify that the charge indicator is ON while the engine is
operating. If the charge indicator is not ON, repair the
problem before operating the engine.
Engine
Page 258
CAUTION
Figure 414
Figure 415
SP001693