Finish Washing
1.
Rinse the washed parts in a rinsing sink filled with clean
kerosene by gently shaking each part in the kerosene.
2.
Using clean, lint free cloth, wipe each rinsed part to
remove dripping kerosene.
NOTE:
Dry hub (1), spindle (2) and hold flange (3) by
spraying with compressed air until they are dry
and clean. Let other parts dry naturally until they
are dry and clean. After drying, coat every part
with oil. Take notice that all pins and ball / roller
for the bearings are carefully separated and
surfaces protected from any damage to prevent
flaws to the pins and ball / rollers.
Travel Motor
Page 48
Figure 89
Figure 90
SP001686