Doosan DX60R Shop Manual page 591

D. Pick the end portion of the ring and pull it out to
remove the ring off the groove.
5. Remove cover (8) from hub (1) making use of the cover
removable tool.
6. Remove O-ring (29) from cover (8).
NOTE: O-ring (29) might prevent the cover from sliding
out. If it is difficult to lift the cover off, shake the
cover loose by tapping on it with a plastic
hammer, so that the cover will slide out without
cocking.
NOTE:
Do not reuse O-ring (29) which has been
removed.
Input Gear Removal
1. Remove retaining ring (24) from shaft (102).
Be careful when removing the retaining ring. You
could become injured if tip of the pliers comes out of
the retaining ring hole, and the retaining ring jumps
out.
2. Draw out input gear (6) from shaft (102).
Travel Motor
CAUTION
Figure 37
Figure 38
Figure 39
Figure 40
SP001686
Page 33