Doosan DX60R Shop Manual page 615

Install Retaining Rings
1. Check if any spindle (2), hold flange (3), RV gear
assembly, and the spacer (12) a newly replaced parts.
NOTE:
If none of them is a newly replaced part, go to
the next step. If any of them is a newly replaced
part, adjust the axial clearance of tapered roller
bearing (22) before doing to the next step. If
only retaining rings (20) is to be replaced with a
new one a retaining ring (20) that is identical
with or equivalent to the replaced retaining ring
must be selected from 15 available types.
2. Install retaining rings (20) into the retaining ring grooves in
the hold flange (30).
NOTE:
Install the two retaining rings in the same
position as before disassembly, as indicated by
the match marks on the hold flange. if new
retaining ring is used, select this retaining ring
having an appropriate thickness (see after item)
and install it into the retaining ring grooves in
the hold flange.
3. Install two retaining rings (25) into the retaining ring
grooves in the crank shaft (9).
Travel Motor
Figure 107
Figure 108
SP001686
Page 57