Doosan DX60R Shop Manual page 482

Applying active oil to the surface of the shaft enables
the assembly without any damage to the sliper seal.
5. Fix the position of the shaft and press the hub carefully
into shaft with both being parallel each other.
6. Use a plastic (or urbber) hammer to tap the hub until it is
inserted completely.
Tap the Hub in a zigzag pattern that it does not tilt to
one side.
7. Assemble the shim, spacer and install the retaining ring.
8. Set the O-ring (1AG95) in its place and assemble the
cover in the direction as shown in the figure.
9. Engage the cover bolt (M10) at torque of 5 ~ 6 kg•m.
After the completion of the assembly, a start-up and a
rotation torque tests should be performed for the sliper
seal to seat in its place properly.
Center Joint (Swivel)
Page 10
CAUTION
CAUTION
CAUTION
Figure 7
Figure 8
FG013241
FG013242
SP001628