Doosan DX60R Shop Manual page 120

I. "Loctite" Fastener Adhesives
Product
Low strength for 6 mm (1/4") or
222
smaller fasteners.
Medium strength for 6 mm (1/4") and
242 or 243
larger fasteners.
High strength for high grade fasteners
262
subject to shock, stress and vibration.
Extra high strength for fine thread
271
fasteners up to 25 mm (1") diameter.
High temperature/high strength for
272 hostile environments to 232°C
(450°F).
Extra high strength for coarse thread
277 fasteners 25 mm (1") diameter and
larger.
II. "Loctite" Pipe Thread Sealant
Product
"No-filler/nonclog" formula for high-
pressure hydraulic systems. Over
545
application will not restrict or foul
system components.
Solvent resistant, higher viscosity
656
tapered thread sealer.
III. "Loctite" gasket/flange sealer
Product
Gasket eliminator specifically made
for aluminum flanges/surfaces. For
518
hydraulic systems to 34,475 kPa
(5,000 psi).
Low-pressure/wide-gap gasket
eliminator compound. Fills gaps to
504
0.0012 mm (0.030"), cures to rigid
seal.
General purpose, fast setup, flexible-
cure gasket eliminator. For nonrigid
515
assemblies subject to shock, vibration
or deflection.
Standard Torques
Page 14
Application
Application
Application
Color Removal
Purple Hand tools
Blue Hand tools
Heat/260°C (500°F)
Remove HOT
Red
(NO solvent)
Heat/260°C (500°F)
Red
Remove HOT
Heat/316°C (600°F)
Red
Remove HOT
Heat/260°C (500°F)
Red
Remove HOT
Color Removal
Purple Hand tools
White Hand tools
Color
Use Locquic "N" primer for fast (1/2 - 4
Red
hours) setup. Unprimed setup 4 - 24 hours.
Use Locquic "N" primer for faster (1/2 - 4
Orange
hours) setup. Unprimed setup 4 - 24 hours.
Use Locquic "N" primer for faster (1/4 - 2
Purple
hours) setup. Unprimed setup 1 - 12 hours.
Breakaway Cure
Strength (in lb) of
Sealer Alone
45
80
160
160
180
210
Required Setup
4 Hours (or 1/2
hour with Locquic
"T" Primer)
4 Hours (or 1/2
hour with Locquic
"T" Primer)
Notes
SP000813