3.
Remove the through bolt (1, Figure 410), pulley half (2,
Figure 410), flywheel (3, Figure 410), flat washer (4, Figure
410), bearings (5, Figure 410), and spacer (6, Figure 410).
4.
Remove the screws (1, Figure 411) and the stator
assembly (2, Figure 411).
5.
Remove the rear bearing (3, Figure 411).
Reassembly of Dynamo
1.
Reinstall the rear bearing (3, Figure 412).
2.
Reinstall the stator (2, Figure 412) and screws.
3.
Reinstall the front bearings (5, Figure 413) and spacer (6,
Figure 413).
4.
Reinstall the flat washer (4, Figure 413), flywheel (3, Figure
413, pulley half (2, Figure 413) and through bolt (1, Figure
413).
Engine
Figure 410
Figure 411
Figure 412
Figure 413
SP001693
Page 257