Doosan DX60R Shop Manual page 550

9. Remove the half collar (R7).
10. Remove the pinion shaft (R2).
When removing the pinion shaft, be careful not to drop
it. If it is hard to remove, lightly strike it with a plastic
hammer.
11. Remove the taper roller bearing (R4).
12. Remove the oil seal (R5).
The removed oil seal must not be used again.
When removing it, exercise care to prevent damage to
the outer races of the taper roller bearings.
Disassembling is finished, check each component throughly.
Swing Motor
Page 36
CAUTION
CAUTION
Figure 56
Figure 57
Figure 58
Figure 59
SP001630