Doosan DX60R Shop Manual page 605

3. Pull out the outer rings of tapered roller bearings (22) from
spindle (2).
Disassembling Hold Flange
1. Remove the outer rings of tapered roller bearings (22).
NOTE: Remove the outer ring only when the ball
bearing is to be replaced.
Washing
1. Separate hub (1), spindle (2), cover (8), and rear flange
(101) from other parts (hereafter called the built-in parts).
2. Wash the built-in parts in a washing bath.
NOTE: Carefully wash to remove any darts from
external surfaces. Wash all parts carefully with
kerosene.
Wash all parts carefully with kerosene. Take notice of
a possibility of due to combustibility.
3. Full a primary washing vessel with kerosene. Put the
built-in parts in it and wash them.
NOTE: To prevent the built-in parts from being marred
by dirt during washing, immerse the parts in
kerosene long enough for any dirt or oil to
become loose and surface before washing
them.
Travel Motor
CAUTION
Figure 86
Figure 87
Figure 88
SP001686
Page 47