Doosan DX60R Shop Manual page 27

If the machine catches fire, it may lead to serious personal
injury or death. If a fire occurs during operation, escape from
the machine as follows:
• Turn the starter switch to the "O" (OFF) position and
shut down engine.
• If there is time, use the fire extinguisher to put out as
much of the fire as possible.
• Use the handrails and steps to escape from the
machine.
The above is the basic method for escaping from the machine,
but changing the method may be necessary according to the
conditions, so carry out practice drills at the work site.
Protection from Falling or Flying Objects
On work sites where there is a danger that falling objects or
flying objects may hit the operator's cabin select a guard to
match the operating conditions to protect the operator.
Working in mines, tunnels, deep pits or on loose or wet surfaces
could produce danger of falling rock or hazardous flying
objects. Additional protection for the operator's cabin could be
required in the form of a FOPS (Falling Object Protective
Structure) or window guards.
Never attempt to alter or modify any protective structure
reinforcement system, by drilling holes, welding, remounting or
relocating fasteners. Any serious impact or damage to the
system requires a
Reinstallation, recertification and/or replacement of the system
may be necessary.
Contact your DOOSAN distributor for available safety guards
and/or recommendations to prevent danger of getting hit by
objects that could strike the operator's cabin. Make sure that all
other work site crew members are kept well away from the
excavator and safe from possible hazards.
For breaker operation, install a front guard and apply a
laminated coating sheet to the front glass. Contact your
DOOSAN distributor for recommendations.
When carrying out demolition or cutting operation, install a front
guard and top guard, and apply a laminated coating sheet to
the front glass.
When working in mines or quarries where there is a danger of
falling rock, install FOPS (Falling Objects Protective Structure)
and apply a laminated coating sheet to the front glass.
If any glass on the machine is broken, replace it with new glass
immediately.
Track Excavator Safety
complete integrity
Figure 9
reevaluation.
Figure 10
HAOA110L
HAOA100L
SP001614
Page 19