Doosan DX60R Shop Manual page 249

Remove the engine oil filter as follows:
1. Turn the engine oil filter (2, Figure 76) counterclockwise
(3, Figure 76) using a filter wrench.
2. Clean the engine oil filter mounting face.
3. Lightly coat the gasket on the new oil filter with engine oil.
Install the new engine oil filter manually by turning it clock
wise (4, Figure 76) until it contacts the mounting surface.
Tighten an additional 3/4 of a turn using the filter wrench.
Engine Oil Fliter Part No.
4TNV98-E
*Consult the operation manual for the driven machine for
applicability of the dust proof filter.
4. Add new engine oil to the engine as specified in Adding
Engine Oil on page 4-14.
Never overfill the engine with engine oil.
Always keep the oil level between the upper and lower
lines on the oil cap / dipstick.
5. Warm up the engine by running it for five minutes and
check for any engine oil leaks.
6. After engine is warm, shut it off and let it sit for 10 minutes.
7. Recheck the engine oil level.
8. Add engine oil (5, Figure 77) as needed until the level is
between the upper (2, Figure 77) and lower lines (3,
Figure 77) shown on the dipstick (1, Figure 77).
9. Reinstall the oil filler cap (4, Figure 77). If any engine oil is
spilled, wipe it away with a clean cloth.
Engine
Standard
129150-35153 119005-35151
CAUTION
Dust proof*
Figure 76
Figure 77
SP001693
Page 69