Figure 3: The Controls/Connectors On The Rear Of The Pump (System With Rear Exhaust And Castors/Levelling Feet Fitted) - Edwards GXS Series Instruction Manual

Figure 3 The controls/connectors on the rear of the pump (system with rear exhaust and castors/
levelling feet fitted)
1. Ethernet LAN LED (green) 1. Ethernet LAN LED (green)
3. Ethernet connection 3. Ethernet connection
5. System interface (PDT and serial SIM) 5. System interface (PDT and serial SIM)
7. Running and alarm LEDs (2 colours, 7. Running and alarm LEDs (2 colours,
either green or red) either green or red)
10. Pneumatic valve inlet connection (if 10. Pneumatic valve inlet connection (if
fitted) fitted)
12. High flow purge air filter (if fitted) 12. High flow purge air filter (if fitted)
14. Auxiliary gauge or pressure input 14. Auxiliary gauge or pressure input
connection (if fitted) connection (if fitted)
17. Purge gas connection 17. Purge gas connection
19. RF earth (ground) stud 19. RF earth (ground) stud
21. Levelling foot (if fitted) 21. Levelling foot (if fitted)
23. Micro TIM connections (if fitted) 23. Micro TIM connections (if fitted)
25. Electrical connector locking mechanism 25. Electrical connector locking mechanism
M58800880_H - Introduction
Page 14
2. Ethernet link LED (yellow) 2. Ethernet link LED (yellow)
4. Power LED (green) 4. Power LED (green)
6. Waring LED (yellow) 6. Waring LED (yellow)
8. Accessory interface 8. Accessory interface
9. Micro TIM in control LED (green) 9. Micro TIM in control LED (green)
11. DP clean solvent flush fluid connection (if 11. DP clean solvent flush fluid connection (if
fitted) fitted)
13. Cooling water in 13. Cooling water in
15. Protective earth (ground) stud 15. Protective earth (ground) stud
16. Purge gas rotameter (optional) 16. Purge gas rotameter (optional)
18. Cooling water out 18. Cooling water out
20. Exhaust gas outlet connection 20. Exhaust gas outlet connection
22. EMS interface 22. EMS interface
24. Electrical supply connector 24. Electrical supply connector